Use a hole saw to drill through the plywood and halfway through the door.
Old door enlarge existing door handle hole.
Mark the center of the existing hole on the edge of the door.
Measure the size of the existing hole in your door using a tape measure.
They were moved down to 1m but now there are holes where the handles and strike plate used to be.
Then mark centerlines on the plywood block.
Turn the door over remove the plywood disk from the hole saw and use the hole saw to drill through the other side of the door until the two holes meet.
Then bore into the plywood and through the hole behind it.
See below for a shopping list and tools subscribe to this.
To overcome this problem fasten a piece of 1 2 inch plywood over the existing hole.
When enlarging a lockset hole mark the centerlines of the old hole on the door.
The door handles in this house were set too high 1 4m.
The plywood will hold the pilot bit on track until the saw starts cutting.
See more ideas about doors door color painted doors.
2 draw a circle on a sheet of plywood measuring the same size as the hole in your door using a compass to make the circle.